Search found 235 matches
When you say a doubler on the vertical face, I see the cross member came with two new triangle shims.....do you omit these and use a wider piece the same thickness as the shims for the doubler, or do you add pieces shaped around the triangle profile of the cross member on the vertical face?
Hi Jim, Yes, I had to cut out the old bolts, so I'm using the two plate method and tig welding a plate on top and bottom with tubes welded to them vertically so I can run the bolts all the way through the frame from the top but not crush the thin frame when torqueing. The bottom plate will be welded...
Hey Kelly, I need 4 but was thinking 6 in case a screw one or two up since I'm pretty sure I'll need to cut them down a little. Thanks for the reply! Let me know how much you want for them including shipping. Thanks again Tim I'm in Fleetwood PA 19522 P.S was also looking for two 2L connecting rod b...
Looking for some old head bolts to re-purpose as cross member bolts on my cross member to frame repair. Figured if someone has some laying around and wants to make a few bucks I'd rather spend the money here than Amazon.
- Fri Apr 05, 2019 10:12 pm
- Forum: Tech Questions and Advice
- Topic: Aux shaft bearing jig?
- Replies: 4
- Views: 346
Thanks Jim, They took them out at the machine shop, and I did get them re installed, but the shaft is really tight on the bearings. They appear to be in straight and all the oil holes are lined up properly. I might dress them up a bit and see if I can loosen up the fit. They might have squeezed a li...