X1/9 master cylinder question

The forum for all of your technical questions on your classic FIAT autos
Post Reply
rss719
Posts: 1
Joined: Fri Dec 15, 2017 8:01 pm
Last Name: Stewart
First Name: Ray

X1/9 master cylinder question

Post by rss719 » Sat Dec 16, 2017 1:00 pm

Might someone have an X1/9 master cylinder sitting around that they could take some measurements of for me? I was a long time FIAT guy years ago (forgot my mirafiori ID and password and have had about 5 emails since) and am working on a project that needs a frame/side mounted master cylinder, 3/4 ID and remote reservoirs. X1/9 might be just right but I'm wondering if anyone can measure the bolt holes, not just center to center but the measurements on both the horizontal and vertical plane. My memory and looking at pictures online tell me it is something like 1 1/4 vert. and 1 1/2 horiz. Does anyone have on laying around they would be kind enough to measure? Thanks in advance
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests