Wanted: Any parts you have for 1972 Fiat 128 Sedan

FIAT cars and parts wanted
User avatar
elibarb
Posts: 110
Joined: Sun Jan 24, 2016 11:21 am
Last Name:
Contact:

Re: Wanted: Any parts you have for 1972 Fiat 128 Sedan

Post by elibarb » Tue Jun 13, 2017 12:38 pm

I have a parts book for a 128 if you want it. cost is 5$ plus shipping. It has also been scanned and uploaded into the library.

Also have a piston set for 86mm bore SOHC engine, nearly free 25 + shipping.

Fiat p/n on the canister is 5880984, but I'm not positive that's accurate. They appear to be NOS with a bit of grease in the recesses. There's a remote possibility that they're used, but if they are then only very lightly used. Factory scoring marks on the sides are still visible. The canister mentions these are .4 oversized, but my micrometer is pretty basic so I can't guarantee that or that the canister matches the pistons. However based on the Mondial part numbers stamped into the piston and from referencing the old archived xweb forums it appears they should indeed be 86.4mm. A search for "fiat Mondial piston 2933" turns up the xweb forum entry where the details are discussed.

Includes wrist pins, but not rings or circlips.
IMG_1123.JPG
IMG_1123.JPG (2.44 MiB) Viewed 200 times
IMG_1118.JPG
IMG_1118.JPG (1.94 MiB) Viewed 200 times
IMG_1117.JPG
IMG_1117.JPG (2.11 MiB) Viewed 200 times
IMG_1114.JPG
IMG_1114.JPG (2.07 MiB) Viewed 200 times
Eli B.
76 131 4 door
67 850 coupe
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest